5-10 Magellan
®
8300/8400
Scale Intercharacter Delay
Sets the delay between the end of one character and the beginning of the
next, in 10 millisecond increments.
To specify the intercharacter delay:
1. Scan the SWITCH bar code.
2. Scan the bar code below,
SCALE INTERCHARACTER DELAY.
You’ll need to cover any unused bar codes on this and the facing
page to ensure that the scanner reads only the bar code you intend
to scan.
3. Scan the appropriate digits from the keypad in
Appendix A that rep-
resent the desired delay. The selectable range is 0-100, which is the
delay in 10-millisecond increments. Pad all single and double digit
numbers with leading zeroes to yield a three-digit entry (000-100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SCALE INTERCHARACTER DELAY
To Next Page
Loading...
Need help?
General
