REFERENCES
5.10 DISPLAY PARAMETERS (SOME M8300 MODELS ONLY)
5.10.1 Display Mode
The user can control the reader display behavior according to the following
selections:
Normal mode: When a barcode is read with the reader:
• The code is sent to the Host.
• The reader display is
not cleared
• There is no Local Echo to the reader display.
. Therefore if any previous data was displayed
on the reader screen it remains.
Clear Display After Decode mode: When a barcode is read with the reader:
• The code is sent to the Host.
• The reader display
is cleared
• There is no Local Echo of the code to the reader display.
. Therefore if any previous data was displayed on
the reader screen it is cancelled and the screen remains blank.
Local Echo mode: When a barcode is read with the reader:
• The code is sent to the Host.
• The reader display
is cleared
• The code is also sent to the reader display (Local Echo).
.
• The cursor is positioned after the last printed character on the reader display.
Host messages sent to the reader
are always written to the reader display.
To Next Page
Loading...
Need help?
General
