Datalogic PowerScan D8330

POWERSCAN® D8330/M8300/M8300-DK
186
5.11 CONFIGURATION EDITING COMMANDS
The following commands carry out their specific function and then exit the
configuration environment.
Command Description
Ì$+$*oÎ
Restore PowerScan
®
reader default
configuration (see the relative Quick Reference
Guide for default settings)
Ì$+$!KÎ
Transmit the PowerScan
®
D8330 or
PowerScan
®
M8300 software release
Ì$+$&_Î
Transmit PowerScan
®
reader configuration in
ASCII format.
This command is not effective with Pen
emulation interface.
Ì$+RX0$-qÎ
Restore BC-80X0 default configuration (see the
relative Quick Reference Guide
for default
settings)
Ì$+RX1$-vÎ
Transmit the BC-80X0 Software release.
Ì$+RX2$-{Î
Transmit BC-80X0 configuration in ASCII format.
This command is not effective with Pen
emulation interface.