Datalogic PowerScan D8330 User Manual

REFERENCES
191
5.15 DEFAULT PARAMETERS FOR POS TERMINALS
The default values of the RS-232 and Data Format parameters for POS terminals are
listed in the following table:
NIXDORF Mode A FUJITSU ICL Mode
RS-232 Group
Baud Rate 9600 9600 9600
Parity Odd None Even
Data Bits 8 8 8
Stop Bits 1 1 1
Handshaking Hardware (RTS/CTS) None RTS always ON
ACK/NACK Protocol
Disabled
Disabled
Disabled
FIFO
Disabled
Enabled
Enabled
Inter-Character Delay
Disabled
Disabled
Disabled
RX Timeout
9.9 sec
2 sec
9.9 sec
Serial Trigger Lock
Disabled
Disabled
Disabled
Data Format Group
Code Identifier
Custom
Custom
Custom
Header
No Header
No Header
No Header
Terminator
CR
CR
CR
Field Adjustment
Disabled
Disabled
Disabled
Code Length TX
Not Transmitted
Not Transmitted
Not Transmitted
Character Replacement
Disabled
Disabled
Disabled
Address Stamping
Disabled
Disabled
Disabled
Address Delimiter
Disabled
Disabled
Disabled
Time Stamping
Disabled
Disabled
Disabled
Time Delimiter
Disabled
Disabled
Disabled
The table below lists all the Code Identifiers available for the POS terminals:
CODE NIXDORF Mode A FUJITSU ICL Mode
UPC-A
A0
A
A
UPC-E
C0
E
E
EAN-8
B
FF
FF
EAN-13
A
F
F
Code 39
M
None
C [code length]
Codabar
N
None
N [code length]
Code 128 K None L [code length]
Interleaved 2 of 5 I None I [code length]
Code 93 L None None
Industrial 2 of 5 H None H [code length]
UCC/EAN 128
P
None
L [code length]
MSI
O
None
None
GS1 DATABAR™
E
None
None
Other
None
None
None

Datalogic PowerScan D8330 Specifications

General

Brand	Datalogic
Model	PowerScan D8330
Category	Barcode Reader
Language	English