40 PowerScan
®
RF Scanner
Interface (I/F)
Selection
It is very important that the scanner and Base Station are each config-
ured to operate with the same interface (I/F) type as the host terminal.
NOTE
The Base Station uses a “smart” cable, which auto-
matically sets the Base Station to the correct I/F
upon power-up and connection to the appropriate
host.
SET -------------------------------------------
Enable Wand Emulation
Enable Standard
RS-232
Enable Wincor Nixdorf RS-232
Enable IBM Port 5B
Enable IBM Port 9B
Enable IBM Port 17
Enable IBM Port E
To Next Page
Loading...
