ENTER/EXIT PROGRAMMING MODE READING PARAMETERS
108
QUICKSCAN™ 2500
Decode Negative Image
Enable/Disable the ability to decode a negative image for all symbologies. When this
feature is enabled, you will be unable to read normally-printed labels or programming
labels in this manual. Scan the “Disable” bar code below to return the reader to its
default for this feature. To set decoding for only 2D codes, go to "
2D Normal/Inverse
Symbol Control
" on page 199. For additional options, see the Aladdin configuration
application.
Image Capture
For information and a list of options for Image Capture, use the Datalogic Aladdin con-
figuration application, available for free download from the Datalogic Scanning website.
NOTE: Unlike some programming features and options, Decode Negative
Image selections require that you scan only one programming bar code
label. DO NOT scan an ENTER/EXIT bar code prior to scanning a Decode
Negative Image bar code.
CAUTION: When this feature is enabled, you will be unable to read other
programming labels in this manual.
$CIPVR00
Decode Negative Image = Disable
Decode Negative Image = Enable
$CIPVR01
To Next Page
Loading...
