SETUP
26
QUICKSCAN™ 2500
Software Version Transmission
The software version of the device can be transmitted over the RS-232, Keyboard and
USB interfaces by scanning the following label.
Transmit Software Version
Resetting the Product Configuration to Defaults
Restore Custom Default Configuration
If you aren't sure what programming options are in your reader, or you've changed
some options and want to restore the Custom Default Configuration that may have
been saved in the reader, scan the Restore Custom Default Configuration bar code
below. This will restore the custom configuration for the currently active interface.
Restore Custom Default Configuration
Restore Factory Configuration
If you want to restore the Factory Configuration for your reader, scan either the Restore
USA Factory Configuration bar code or the Restore EU Factory Configuration bar code
below. Both labels restore the reader configuration to the factory settings, including the
interface type. The USA label restores Label IDs to those historically used in the USA.
The EU label restores Label IDs to those historically used in Europe. The Label ID sets for
USA and EU are shown in the “Label ID” Section on
page 81 of this manual.
Restore USA Factory Configuration
Restore EU Factory Configuration
The programming items listed in the following sections show the factory default settings
for each of the menu commands.
NOTE: Custom defaults are based on the interface type. Configure the
reader for the correct interface before scanning this label.
To Next Page
Loading...
