Datalogic QuickScan 2500 Series - Label ID Symbology Selection

ENTER/EXIT PROGRAMMING MODE DATA FORMAT
82 QUICKSCAN™ 2500
Label ID Symbology Selection
This option selects the symbology for which a Label ID is to be configured. See "Label ID:
Set Individually Per Symbology" on page 277
for full instructions.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
$CABID
Set UPC-A Label ID Character(s)
Set UPC-A/P2 Label ID Character(s)
$CA2ID
$CA5ID
Set UPC-A/P5 Label ID Character(s)
Set UPC-E Label ID Character(s)
$CEBID
$CE2ID
Set UPC-E/P2 Label ID Character(s)
Set UPC-E/P5 Label ID Character(s)
$CE5ID
$C3BID
Set EAN-13 Label ID Character(s)