EasyManuals Logo

Datalogic Touch 65 Quick Reference

Datalogic Touch 65
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
PEN READER CONFIGURATION
Read the RESTORE DEFAULT
code, then read the PEN
interface selection code.
RESTORE DEFAULT
iPk
iPk
iPk
PEN
i$1#k
i$1#k
i$1#k
DEFAULT VALUES
USB DEFAULT SETTINGS
DATA FORMAT
: code identifier disabled, no field adjustment,
code length not transmitted, character replacement disabled.
USB KEYBOARD
: USA keyboard, inter-character and inter-
code delays disabled, control character emulation =
ctrl+shift+key;
USB COM
: no handshaking, delay disabled, rx timeout 5 sec.,
ack/nack disabled, FIFO enabled, serial trigger lock disabled;
Default Headers and Terminators for each USB mode:
-
USB-KBD: no header, terminator = ENTER
-
USB-KBD-ALT-MODE: no header, terminator = CR
-
USB-COM: no header, terminator = CR-LF
-
USB-IBM-TABLE TOP: not applicable
-
USB-IBM-HAND HELD: not applicable
RS232 Standard DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 5 sec., ack/nack disabled, FIFO
enabled, serial trigger lock disabled;
DATA FORMAT
: code identifier disabled, no field adjustment,
code length not transmitted, no header, terminator = CR-LF,
character replacement disabled
RS232 Nixdorf DEFAULT SETTINGS
9600 baud, parity odd, 8 data bits, 1 stop bit, handshaking
hardware (RTS/CTS), delay disabled, rx timeout 9.9 sec.,
ack/nack disabled, FIFO enabled, serial trigger lock disabled;
DATA FORMAT
: code identifier enabled, no field adjustment,
code length not transmitted, no header, terminator = CR,
character replacement disabled
WEDGE (continued)
IBM Terminals 31xx, 32xx, 34xx, 37xx:
To select the interface for these IBM Terminals, read the
correct KEY TRANSMISSION
code. Select the
KEYBOARD TYPE
if necessary (default = advanced
keyboard).
KEY TRANSMISSION MODE
make-only keyboard
i$1Pk
i$1Pk
i$1Pk
make-break keyboard
i$1Ik
i$1Ik
i$1Ik
KEYBOARD TYPE
advanced keyboard
i',fk
i',fk
i',fk
typewriter keyboard
i',ak
i',ak
i',ak
The following interface selection allows barcodes sent to
the PC to be interpreted correctly independently from the
Keyboard Nationality used. You do not need to make a
Keyboard Nationality selection.
(default = Num Lock Unchanged)
Make sure the Num Lock key on your keyboard is ON.
IBM AT - ALT mode
i$1k
i$1k
i$1k
PC Notebook - ALT mode
i$1k
i$1k
i$1k

Other manuals for Datalogic Touch 65

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic Touch 65 and is the answer not in the manual?

Datalogic Touch 65 Specifications

General IconGeneral
InterfaceUSB, RS-232, Keyboard Wedge
TypeHandheld
Resolution4 mils
Drop Resistance1.5 m
Scan Rate100 scans/sec
Supported Barcodes1D
Operating Temperature0°C
Storage Temperature-20°C
Humidity5 to 95%
Power Supply5V DC

Related product manuals