M-Class 45
PRINTHEAD CLEANING
Controls the printhead cleaning routine.
CLEAN HEAD SCHEDULE
000 in. (* 1000)
Specifies the inch (or centimeter) count to reach before prompting a printhead
cleaning. If the number specified is exceeded three times, the printer will fault until
cleaning is initiated.
Notes: The default value (zero) disables this function. Also, the number specified is
multiplied by one thousand.
CLEAN HEAD COUNTER
0 in.
Indicates the number of inches (or centimeters) since printhead cleaning was last
initiated.
RESET COUNTER
Allows the clean head counter to be set to zero
CLEAN HEAD NOW
Initiates printhead cleaning and resets the Clean Head Counter.
Notes:
Remove ribbon, if installed.
Enter Menu Mode / Media Settings / Media Type and set the printer for Direct Thermal.
Ensure that full width media is installed.
See Section 6.1 for detailed instructions.
To Next Page
Loading...
Need help?
General
