Datamax Mark II M-4206 User Manual

62 M-Class
5.2 Display Messages
The printer displays several different types of information (if not in the menu system or Quick Test Mode):
 User Prompts and Condition Messages (also see Section 5.1.1 for a listing of the Enter/Exit Prompts)
 Application and Boot Loader Updating Messages (see Section 6.8)
 Fault and Warning Messages (see Section 7.1)
5.2.1 User Prompts and Condition Messages
User Prompts alert the operator to a required action. Condition Messages are used to indicate an operational state.
User Prompts and Condition Messages
Displayed Message Description Condition(s)
!
!!
DMFBSJOH!GBVMUT!
!
The printer is trying to clear a fault
condition.
Occurs when the FEED Key is pressed after the
correction of a fault.
!
!
DBMJCSBUJOH!
A media calibration is being performed. The FEED Key was pressed and held.
!
DBODFM!SFQSJOU@!
FOUFS!LFZ!>!ZFT!
!
The CANCEL or TEST Key was
pressed during the fault handling
process.
The faulted label will be cancelled if ENTER is
pressed, then the remaining labels in the batch
will be printed.
!
DBODFM!CBUDI@!
FOUFS!LFZ!>!ZFT!
!
The CANCEL or TEST Key was
pressed during a batch job.
The current print batch will be cancelled if
ENTER is pressed; the remaining labels will not
be printed.
!
!
QBVTFE!
The printer is paused or offline. The printer is in a paused condition.

Datamax Mark II M-4206 Specifications

General

Print Resolution	203 dpi
Type	Label Printer
Print Method	Thermal Transfer
Max Print Speed	6 inches per second
Memory	16 MB SDRAM, 8 MB Flash
Interfaces	USB, Serial, Parallel
Media Width	4.5 inches
Media Length	0.25" to 99"
Max Print Width	4.25 inches (108 mm)