60 M-Class
5.1.7 Diagnostics
HEX DUMP MODE
Most commonly used for troubleshooting. Prints data and instructions received
from the host rather than interpreting them as label formats; see Section 7.2.
ENABLED
Prints raw ASCII data received from the host rather than executing the commands.
DISABLED
Executes and prints label formats (normal operating mode).
OPTIONS TESTING
Allows or performs diagnostics of specific options within the printer.
TEST PRESENT SENSOR
Performs a functional test of the present sensor.
TEST CUTTER
Performs a functional test of the cutter.
PERFORM TEST
1 TIME
The test will cycle the selected number of times (1, 10, or 100) with the results
displayed following each attempt.
PRINT TEST RATE (min)
000 (0-120)
The number of minutes to delay between the printing of batches of Quick Test
Labels.
SENSOR READINGS
Analog Sensor readings are displayed.
THR TRAN RIBM 24V PS HD RANK
255 255 255 255 255 255 255
Live sensor values are displayed. Maximum values are shown in this example,
where:
THR = thermistor sensor;
TRAN = transmissive (gap) media sensor (REFL is shown if the SENSOR TYPE
is set to ‘reflective’);
RIB M = ribbon motion sensor;
24V = 24 volt DC power supply sensor;
PS = Present sensor;
HD = head-down sensor; and,
RANK = the value of the printhead ranking resistor.
RIBBON SENSOR LIMITS
Displays ribbon sensor ADC low and high values used for motion detection.
RIBBON ADC LOW HIGH
070 164
Approximate default values are shown here (actual values will vary).
To Next Page
Loading...
Need help?
General
