RSS_v180808n RSS Series Page 25
5. IPC-1-R Network Gang Control Card
Item # 1340066
The IPC-1-R Control Card installs from the rear of the chassis in the 2nd
control card slot only. This is the third slot on the left (facing the rear), next to
the power supply. The physical size of the IPC-1-R components require 2
slots. Note: It is recommended that any removal or insertion of a control card
be performed with power off to prevent possible unintentional switching of the
switch cards.
The card provides the following connections:
External Power Input. Connection for external power supply, singularly, or as
a supplement to an internal supply for dual redundant power.
Mating Connector kit # 1940164
Gang Expansion. RJ11 connection for connection to additional chassiss for
large gang switching applications.
Ethernet. 10/100base-T Network connection
5.1. IPC-1-R Configuration
5.1.1. Setting I/P Address
IPC-1-R comes with factory installed IP address 192.168.1.254 you may need to change this address.
Consult your Network Administrator to determine the appropriate IP address. The IP address can be set in any
of four ways:
• Web Browser via the Set-up Page
• Automatically from a DHCP Server
• ARP-Ping
• Dataprobe setip.exe utility
1. Setting the IP address using Web Browser
Access the IPC-1-R with the administrator credentials and select Setup, then IP. Enter the IP address, subnet
mask and gateway. For initial setup the computer accessing the IPC-1-R needs to be on the same subnet as
the IPC-1-R (have a 192.168.1.xx address)
To lock the settings, select the IP Mode: Static. This prevents additional changes to be made with either DHCP
or ARP.
Click Apply and then a Reboot button will appear. Click to Reboot. The new changes will take effect after
reboot.
2. Setting the IP address from a DHCP Server
A DHCP server will automatically assign an IP address (dynamic address) as well as Subnet Mask and Gateway
to the IPC-1-R. If you power up IPC-1-R with the IP Mode set to DHCP, the server will be able to assign an IP
address. Once an IP address is assigned, you must check with the DHCP server to see what address is
To Next Page
Loading...
Need help?
General
