DI-2008 Hardware Manual
Installation
8
6. Follow the on-screen prompts and enter any required information.
7. Software installation is complete - you will now see a “Successful Installation” box - click OK to exit WINDAQ
Installation.
You can now plug the device(s) into your PC. Click on the appropriate program group (specified above — default is
Start > Programs > WINDAQ) and click on “DATAQ Instruments Hardware Manager” to access W
INDAQ software.
Connect the Instrument to Your Computer
DI-2008 instruments can be connected to your computer’s USB port using the provided USB cable. No external
power is required. Connect one end of the communications cable to the instrument port and the other to your PC’s
port.
Note: Use a powered USB hub or a USB port on your PC. Non-powered USB hubs may not have sufficient power to
run the instrument.
To Next Page
Loading...