DP-50 / DP-50D / MP55-B - USERS MANUAL
'PROGRAMMING' MODE
If you are programming your ECR by oneself read carefully this chapter.
If your ECR is already programmed by service specialist, skip this chapter and
read the chapter "MODE R - REGISTERING".
The item price changes are always allowed. For the other item parameters
programming is allowed any moment only for the items with zero turnover. The other
ECR settings can be programmed only after daily Z report.
There are three programming modes:
P, 1 - programming of items and main parameters
P, 2 - programming of specific parameters (tax groups parameters and
the identification number of the tax obligated person -BULSTAT)
P, 3 - Setting up the fiscal memory in use
1 In order to access the mode "Programming" from the 'OFF' state press key 4.
2 - In the left side on the display the letter 'P' is shown and on the next row is shown
an invitation for password entering.
To Next Page
Loading...
