Datecs DP-50 - FUNCTION OF THE KEYS IN PROGRAMMING MODE

DP-50 / DP-50D / MP55-B - USERS MANUAL
FUNCTION OF THE KEYS IN 'PROGRAMMING' MODE
The programming of parameters is organized in a table structure. Each table
consist a given number of rows and any row consist fields. The fields can be symbol
or numeric type. The information of each field can be shown in two modes - field
address or field value. When a programming sub-mode is accessed, the current
position (e.g. the current parameter which can be programmed) is determined on the
display with the field address as is shown on the figure:
Field size
Table No
Row No
Field No
2 . 0 1 . 0 1 . 0 2
The only exception is the table for items programming. When this table is
programmed on the upper display row are shown the first 16 characters from the item
name, stored on the current table row.
The key functions in 'PROGRAMMING' mode are:
Q’ty
/
X
- Moving to the next table. The table with rearmost number is followed
by the table with the smallest number
%+
- Moving to a field with higher number
%-
- Moving to a field with lower number
PRC
- Moving to a row with higher number
VD
- Moving to a row with row with lower number
T
O
T
A
L
- Writing the information entered
STL
- Switching the mode of indication (address / value)
CRD
- Printing the fields value
PLC
- 1.Physically writing into the fiscal memory or into the clock-calendar
the contents of the table given (the operation must be accepted by
pressing the key
0
)
14