Datecs DP-50 - EDITING PARAMETERS AND SYMBOL SELECTION

DP-50 / DP-50D / MP55-B - USERS MANUAL
2. Accessing the row with number "N". For this purpose:
- if the current display mode is “value”, by pressing the key
STL
switch to “address” mode.
- press the key
PLC
- using the numeric keys enter the desired number N
- press again the key
PLC
.
G1
- One position forward when editing a symbol field
G2
- One position backward when editing a symbol field
C
- Clearing the field's contents
The editing of parameter is possible both from "address" state and from
"value" state on the display. With the beginning of the editing automatically the
display state changes to show the fields value. After the parameter editing in order to
save the value modified into ECR's memory the key TOTAL must be pressed. If the
operator omit to press the TOTAL, the last made modifications will be lost.
When editing a symbol field, the symbols are chosen by consecutively
pressing a key, and if the key remain un-pressed for a given time - this will cause the
cursor to move automatically on the next position on the display (this is made in a
similar way as when editing text in a mobile phone). By consecutively pressing the
key PLU, the appropriate alphabet can be chosen - Cyrillic, Latin or digits only. The
current alphabet selected can be determined by the three symbols which appear on
the right upper row:
For Cyrillic (АБВ)
For Latin (ABC)
For digits only (123)
On the figures below is shown how can be chosen the symbols from the
different alphabets.
15