Datecs DP-50 - OTHER OPERATIONAL MODES; CONNECTION TO PC; CONTROL TESTS; PROGRAMMING AND REPORTING TO PC

DP-50 / DP-50D / MP55-B - USERS MANUAL
OTHER MODES
CONNECTION TO PC
From OFF state of the ECR with the key '7' go to state:
"FM READING" .
The speed of communication in this mode is determined by the value in field 8 of
table 2.
CONTROL TESTS
From state 'OFF' of the ECR, with key 8 accesses the state:
0 1 - 8
TEST
The tests are activated with the keys from 1 to 8, the key ‘.’ Is used, and the pressing
the key 0 will cause automatically execution of the tests from 1 to 5.
The tests types are:
1 - Printer test
2 - Display test
3 - Memory test
4 - Keyboard test
5 - Test - reading from the fiscal memory
6 - Test - writing into the fiscal memory
7 - Clock test - the current date and time will be shown till 1 minute expires
from the beginning of this test or till any key is pressed.
8 - Full fiscal memory test
9 - The accumulator voltage level is shown
TOTAL - printing parameters, which identify the ECR.
. - the tests 1 to 5 repeats any 10 minutes in a loop
PROGRAMMING AND REPORTING TO PC
From the ECRs OFF state, by pressing the key 9 you will access the state:
O F F - L I N E
In mode 9 the ECR is waiting for communication – programming and reporting
from PC. The correct communication baud rate must be prior given into PGM1 mode,
table 3 field 8. For programming and reporting is used the application Ecr Tool or its
analog.
DISPLAYING THE ACCUMULTOR LEVEL AND THE CURRENT DATE AND TIME
From the ECRs OFF state, after pressing the key "." for several seconds on
the display the accumulator voltage will be shown, after on the display will appear the
current date and hour.
32