DP-50 / DP-50D / MP55-B - USERS MANUAL
MODE R - REGISTERING
1. In order to access the R mode, from the OFF state press key 1.
2. On the left upper display corner the letter 'R' appears and the operator is invited to
enter his password.
Enter the numeric password sequence and press TOTAL.
FUNCTION OF THE KEYS IN 'REGISTERING' MODE
Function keys
keys G1, G2, G3, G4
They allow to access items or item groups stored on the rows from 1 to 4
respectively into the item parameters table. The key pressing causes accumulation
into the customer bill and also into the quantity and turnover registers of the item or
item group given. The value entered before pressing some of these keys is accepted
as a price. If the price is not entered, the programmed price is used.
Note: It is not allowed an item to be sold, if the price is zero. This will cause
alarm signal to be produced and error message "C" to be shown on the
display.
PLU
Specifies, that the previously entered number is a PLU-code of an item or
item group. Causes an accumulation of the selected PLU into the customer bill.
When the PLU-code is entered, the decimal point is ignored and the value entered is
assumed as integer one.
Note: If the price programmed is zero ( or any of the item parameters is not
allowable - for example the tax group) the operation will be refused and on the
display an error message "C" appears, and sound alarm is produced.
PRC
- Specifies, that the previously entered value is a price. The decimal point
position on the display is checked. This key is used for entering a free price for an
item or item group. First the price value is entered, than is pressed
. Than the
item code or item group code should be specified.
- It is used to select an item by its barcode. By pressing the key PRC before
entering a number, on the display appears "BARCODE", than the operator should
enter the barcode and again press PRC in order to make a sale with the item which
has such barcode.
- for MP-55B
Specifies, that the value entered is a quantity. The decimal point position on
the display is checked. When the ECR works with a scale, the pressing of that key
without prior entered value will cause the quantity from the scale to be received.
PLC
24
To Next Page
Loading...
