Datecs DP-50 - ITEM TURNOVER AND PARAMETER REPORTS

DP-50 / DP-50D / MP55-B - USERS MANUAL
the wish is to go in the main X mode menu or by pressing '<>' if the
wish is to go in 'OFF' mode.
CRD/PY Reporting the items turnover
The report can be executed for all items (by pressing TOTAL) or
selected range of items. The range can be set with determining the
first item. The first item from the range is determined with the row
number from table 1 on which this item is stored. Using the keys %- and
%+ you can move "forward" and "backward" over the table 1 rows.
Pressing the key TOTAL starts the report printing from the first row to
last in PLU database (row 1000).
If before pressing the key TOTAL an integer value n is entered,
the report includes information for only n items with non-zero turnover.
After finishing the report for initial item is set the first item with greater
PLU code and non-zero turnover.
The report includes:
- The PLU-code;
- The row number;
- The name;
- The tax group identification;
- The sold quantity;
- The turnover for the item;
After finishing the report printing for the range selected, a new
report can be chosen for another range. This mode can be leaved with
the key 'Q'ty' to go in the main 'X' menu or with the key "<>" to exit into
the 'OFF' mode.
PLC Reporting the programmed parameters of the items
The report can be executed for all items (by pressing TOTAL) or for a
given items range. The range setting-up is made in the same way as
for the report started with a key PY.
All items parameters are printed for the selected number of items.
After finishing the report printing for the range selected, a new
report can be chosen for another range. This mode can be leaved with
the key 'Q'ty' to go in the main 'X' menu or with the key "<>" to exit into
'OFF' mode.
%+ Office report from the fiscal memory - it includes:
- The date and the time when the fiscal memory is entered into
use.
- Block number,tax value of the enabled tax groups, decimal
point position;
.
29