1. Introduction
a. Description and Specifications ............................................. 1.1
b. Physical Layout .................................................................... 1.6
c. Panel Mounting .................................................................... 1.9
d. Standard Channel Configuration ........................................ 1.10
e. Standard Logic Configuration ............................................. 1.11
f. Using the Front-Panel Setup Buttons .................................1.13
g. Low Battery Warning .......................................................... 1.19
2. Setup
a. Transducer Cabling ............................................................. 2.1
b. Powerup
1. AC Operation ................................................................. 2.4
2. DC Operation ................................................................ 2.5
c. Adjusting LCD Viewing Angle .............................................. 2.7
d. Selecting a Channel for Display .......................................... 2.8
e. Channel Calibration ............................................................. 2.9
f. Setting Channel Filters ...................................................... 2.11
g. Scaling the Bargraph Display ............................................ 2.12
h. Defining Limit Zones .......................................................... 2.13
i. Logic I/O Connections ....................................................... 2.14
j. Analog Output Connections ............................................... 2.16
3. Operation: Use of Front Panel Buttons ................................. 3.1
Appendix A: Complete Standard Configuration ......................... A.1
Appendix B: 4077/Computer RS-232-C Connections ................ B.1
Appendix C: Legend and Indicator Annunciation ....................... C.1
Appendix D: Modifying Input Range and Excitation Level ......... D.1
Appendix E: "Computed" and "Simulated" Calibration ............... E.1
Appendix F: Cabling and Calibration of a 4077 that Uses an
Optional Model 10CJB-2 Bridge Completion Card ..................... F.1
Appendix G: Analog Peak Capture ........................................... G.1
Appendix H: Changing the Battery ............................................ H.1
i
Contents
Section
Page
To Next Page
Loading...
Need help?
General
