7
Check if the floor can support the weight of the refrigerator and the
food inside (1102lb or 500kg total).
▶ It could damage the floor.
Check if the product is placed within the reach of a power point.
If the product is a dispenser model, check that the product is within easy
access of water supply and the humidity around the product is low.
▶ Please select a place with easy access to water supply for the water & ice
dispenser.
Avoid a place with intense heat or a place that is extremely cold.
▶ Install the product with an ambient temperature between 46℉(5℃) and
109℉(43℃).
▶ When it is installed at a place with an extremely cold or hot ambient
temperature, the products operation can be effected and its cooling capacity
will decrease resulting in an increase in power consumption.
● Select an installation place
Do not earth it to a gas pipe
or a telephone cord.
Possibility of explosion,
electric shock or fire.
● Earth the product
● When the wall outlet is not facilitated with
earth There is a risk of electric leakage. At
this time, electric leakage can be
prevented in some cases when it is
plugged in upside down. (But, when it
comes to old buildings, the earthed state
of the power cord could be unstable even
after its cross insertion and it could bring
about an electric shock. In this case, the
product shall be earthed.)
Check if the floor is flat.
▶If the refrigerator is installed on an uneven floor, it will cause vibration and noise.
The product must be earthed properly.
Make sure your power oulet has an earth pin.
▶
When the product fails to operate properly:Make sure to do earth to
prevent electric leakage or an electric shock.
▶
When there is no earth with normal products:When touching the handle
or surface of the product, a minute amount of electric leakage
can be felt. (It can be felt on all products made of electricity conducting
materials (metal plate).It is obliged to use a right angle power plug.Also,
make sure to earth the product.)
<When the wall outlet has an earthed terminal>
▶
It doesn't need earthing. (But, when
the wall outlet has no earthed terminal,
make sure to earth the product.)
<When the wall outlet has no earthed terminal>
▶
When plugging the product into a wall outlet having no earth, connect
the earthed wire to the earth-screw on the back of the product and then
connect the other end to a metallic water pipe or earth-guide.
▶
Never use a wall outlet or an extension cord having no earthed wire.
(Without earth, minute electric leakage can be generated.)
▶
Please refer to the installation manual for installation details.
Ground
Terminal
BRANDSOURCE-SM(EN) 2007.1.23 10:31 AM 페이지7
To Next Page
Loading...
