WP
4
PotentiaMeter
Menus
20
finished the LED will flash continuously until the
knob is moved to the OPEN/LOAD position (if not
operating in continuous mode). You cannot turn off
or change the LED flashing functions.
There are three beeper options, represented by
three icons:
definition of beeper icons
The beeper can be turned off completely, it can
beep momentarily (4 times) when the sample is fin-
ished and then stop, or it can beep continuously
until the knob is turned to the OPEN/LOAD posi-
tion. After you have adjusted the beeper setting, it
will remain as you have set it until you change it
again, and will not be affected by turning the instru-
ment on or off.
EXIT
You may press the EXIT button (the lower left but-
ton) to exit back to the main menu at any time.
Adjusting Calibration
When you need to adjust calibration, press the
upper right button in the system configuration
menu, and you will be brought to the calibration
0x
4x
No beeping.
Beeps four times, then stops.
Beeps continuously until drawer is opened.
To Next Page
Loading...