WP
4
PotentiaMeter
Troubleshooting
58
• Check to make sure your power cord is
securely attached the back of the instru-
ment, and into the power outlet.
• A power surge may have caused a fuse to
blow. To change the fuses, follow these instruc-
tions:
1. Unplug the power cord from the wall and the
instrument.
2. Locate the panel where the power cord plugs in.
The fuse box is on the right side of that panel.
Press in on the release tab and pull the fuse-
holder out.
3. Pull the broken fuse(s) out and replace with a
2.0 Amp 250V fuse.
Caution: Do not use any other kind of fuse or you
will risk damage to your instrument as well as void
your warranty.
4. Replace the fuse-holder and push it into the
fuse-well until the release tab snaps in place.
5. Re-connect the power cord and turn your instru-
ment on. If the fuse blows again, a failed com-
ponent may be causing the problem. Contact
To Next Page
Loading...