Need Help? Visit DefenderCameras.com/support
3
WHAT’S INCLUDED
WHAT YOU’LL NEED
• TV or Monitor
• Hammer Drill & Appropriate Bit
• Phillips (#2) Screwdriver
• Ladder (if required)
• Cable Protectors (if required)
4 CHANNEL MODEL: NS8MP1T4B4
• 1 x NVR with 1TB HDD
• 4 x 4K Ultra HD POE IP Cameras
• 4 x 60ft Ethernet Cables
• 1 x HDMI Cable
• 1 x 6.5ft Ethernet Cable
• 1 x NVR Power Supply
• 1 x USB Mouse
• 4 x Camera Mounting Hardware
• 1 x Quick Start Guide
• 1 x Window Warning Sticker
• 1 x Drilling Template
8 CHANNEL MODEL: NS8MP1T8B8
• 1 x NVR with 1TB HDD
• 8 x 4K Ultra HD POE IP Cameras
• 8 x 60ft Ethernet Cables
• 1 x HDMI Cable
• 1 x 6.5ft Ethernet Cable
• 1 x NVR Power Supply
• 1 x USB Mouse
• 8 x Camera Mounting Hardware
• 1 x Quick Start Guide
• 1 x Window Warning Sticker
• 1 x Drilling Template
FCC / IC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC STATEMENT / DÉCLA RATION IC:
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1)This device may not cause interference.(2)This device must accept any interference, including
interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de license contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :(1)L’appareil ne doit pas produire
de brouillage; (2)L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator and your body.
Cet équipement est conforme aux limites d’exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé. Cet équipement doit être
installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
To Next Page
Loading...
Need help?
General
