01.01.2022 ASSEMBLY AND OPERATING MANUAL DEGER D25H, D60H, D80 and D100 Page 6
1 General
1.1 Introduction
This operating manual has been written for the DEGER systems D25H, D60H, D80 and D100. It is part of
the product and must be kept over the entire lifetime of the DEGER systems. If the DEGER is passed on to a
third party, the assembly manual must also be passed on.
1.2 Fundamental safety notes
This assembly manual must be read completely before the start of assembly work and should always be
available during all assembly work.
Assembly work must only be carried out by qualified specialist personnel.
The total slewing range of the DEGER must be kept free of any objects.
The entire action range of the installed DEGER systems must be protected against unauthorized access by
applying appropriate measures, e.g. a fence. A clear notice to stay clear of the slewing range is mandatory
and must be attached at the accessing area to the DEGER systems.
For all photovoltaic systems acc. to DIN VDE 0185 or 0100 the lightning protection and grounding must be
executed according to country specific guidelines.
Operation of the DEGER systems must not be started without a fully functional wind monitor. The module
surface must be kept in SAFE position (table position), until the function of the wind monitor has been
tested. For more information see assembly instruction “MLD Control EC-6-with CCB”.
If snow has accumulated on the module surface, the module surface must first be cleared. This is
accomplished by manually controlling via the CCB or through the snow sensor (optional for DEGER
systems D60H). If no functioning CCB and/or snow sensor is available, the module surface must be
cleared manually. The snow sensor shall not release from the clearance obligation of the module surface
from snow.
For the DEGER systems D60H and D25H the max. permissible load is 35 kg/m² (this corresponds with
approx. 8 cm wet snow and approx. 15 cm powder snow).
For DEGER systems D80 and D100 the module surface must be cleared if the load reaches and exceeds
10 kg/m² (this corresponds with approx. 2 cm wet snow and approx. 4 cm powder snow).
DEGER recommends an Uninterruptible Power Supply (UPS) to ensure the function of the wind monitor.
1.3 Liability disclaimer
The General Terms and Conditions for Deliveries and Services (GTC) of DEGER are generally valid and
may be accessed on our website at www.DEGER.biz in the publisher information section. The contents of
these documents are continually checked and modified as needed. The assembly manual is also available
for downloading from the website www.DEGER.biz in the dealer section or can be ordered through the
normal sales channels.
Warranty and liability claims for any kind of damage are excluded if they can be traced back to any of the
following causes:
- Inappropriate or unintended use of the DEGER systems
- Operation of the DEGER systems in an unintended environment
- Operation of the DEGER systems while failing to comply with the locally valid statutory safety regulations
- Non-compliance with warnings and safety notes in all documents relevant to the product
- Operation of the DEGER systems under unsound safety and protection conditions
- Unauthorized changes to the DEGER systems’ design, its component parts or their implementation in the
overall installation
- Malfunction of the DEGER systems caused by the effect of connected or adjacent devices beyond the
permissible limiting values
- Disaster situations and force majeure
- Operation of the DEGER systems without proper wind monitors installed
- Installation of non-genuine DEGER replacement parts
- Unauthorized modifications to any parts
- Damages to any third party components (e.g. inverter or modules)
To Next Page
Loading...