Deger D25H - Symbols Used; Representation Rules; Enumerations and Instructions for Actions; Notes on Safety

01.01.2022 ASSEMBLY AND OPERATING MANUAL DEGER D25H, D60H, D80 and D100 Page 7
1.4 Symbols used
The following symbols are used on the DEGER systems and in this document:
Access for unauthorized persons prohibited
Before starting operation, read and follow the operating manual and the safety notes
1.5 Representation rules
1.5.1 Enumerations and instructions for actions
Enumerations
Enumerations are presented with preceding dashes.
- Enumeration
- Enumeration
Instructions for action in a certain order
Instructions for actions that need to be processed in a certain order are successively numbered.
1. Step 1:
2. Step 2:
Instructions for action without a certain order
Instructions for actions that are not required to be processed in a certain order, are highlighted with
preceding dots:
 Instruction for action
 Instruction for action
Results
Results of an action are highlighted with a double-arrow:
>> Result
1.5.2 Notes on safety
The following safety notes are used in this document:
______________________________________________________________________________________
DANGER!
Direct endangerment with high risk, failure to comply will lead to fatal or severe physical injuries.
______________________________________________________________________________________
WARNING!
Possible endangerment with medium risk, failure to comply can lead to fatal or severe physical
injuries.
______________________________________________________________________________________
CAUTION!
Low risk endangerment, failure to comply can lead to medium physical injuries.
______________________________________________________________________________________
ATTENTION!
Danger of material damage, when failing to comply with this note.
______________________________________________________________________________________