Deif CGC 200 - Page 27

1. Open the Parameters page in either tree or list view.
2. Find the parameter you want to change.
3. If the parameter selects an option:
● In Tree view, change the parameter by selecting the option you want from the drop-down list.
● In List view, double click the parameter line you want to change. A dialogue box containing the drop-
down list opens. Select the option you want.
4. If the parameter selects a value:
● In Tree view, change the parameter by changing the value using the slider. Alternatively, type the val-
ue in the box.
● In List view, double click the parameter line you want to change. A dialogue box containing the value
and a slider opens. Change the value using the slider.
Alternatively, click the value. A dialogue box opens where you can type in the value and click OK.
5. See Writing to the controller for information about how to write the changed values to the CGC 200.
4.3.7 Writing to the controller
You can write to the controller by:
● Writing the parameter and input and output values as you change them. To do this, open the Parameter
page in List view. Double click on a parameter to open it. Change the parameter and click Write in the
parameter dialogue box.
● Writing all the parameters in the utility software. Select Parameters, then Write (
). When you are on
the Parameters page, the write icon ( ) is also available on the toolbar.
● Writing information using the batch write function (
) (described below).
● Restoring the controller information from a .bak file, using Restore Device.
Batch write function
CGC 200 installation and commissioning
instructions 4189340806 UK
Commissioning
DEIF A/S Page 27 of 32