1. Introduction
1.1 About the Installation and commissioning instructions
1.1.1 General purpose
These are the Installation and commissioning instructions for DEIF’s Compact Genset Controller, CGC
200. The general purpose is to provide information for the correct installation and commissioning of CGC 200.
Read this manual before installing or commissioning the CGC 200. Failure to do this could re-
sult in human injury or damage to the equipment.
1.1.2 Intended users
The instructions are mainly intended for the people responsible for installing and commissioning the genset
control system.
1.1.3 Revision information
The letter at the end of the document number on the front page indicates the revision number of this docu-
ment.
The latest version of this document can be downloaded at www.deif.com. If you click on the revision letter to
the right of the document name, the revision history is displayed.
1.1.4 Software version
This document is based on the following software versions:
Software type Software version
CGC 200 firmware CGC 200 SW version 1.xx
Utility software Multi-line 2 Utility Software v.3.x.
1.1.5 Getting technical support
You can read about service and support options on the DEIF website, www.deif.com. You can also find con-
tact details on the DEIF website.
You have the following options if you need technical support for your controller:
● Technical documentation: All the product technical documentation is available on the DEIF website.
● Training: You can ask for training.
● Support: You can call or email DEIF. DEIF offers 24-hour support. There may also be a local DEIF sub-
sidiary.
● Service: DEIF engineers can help with design, commissioning, operating and optimisation.
1.1.6 Other technical documentation
The CGC 200 documentation consists of the following documents:
● Quick start guide
● Front panel
● Initial start-up
● Parameter setting
● Wiring diagram
CGC 200 installation and commissioning
instructions 4189340806 UK
Introduction
DEIF A/S Page 3 of 32
To Next Page
Loading...
