2.2.5 Connecting the terminals
The wiring is connected to the controller terminals using pull-apart PCB terminal blocks.
For the MPU input, a magnetic head signal input and a shielding line are recommended.
Protect the controller terminals from static discharge during installation.
For safety reasons, the work must be carried out by qualified personnel.
To connect the terminals:
1. Connect each wire to the correct connection on the terminal block, then tighten the screw using a flat-
bladed screwdriver.
2. Make sure that the removable part of the terminal block is pressed all the way into the terminal block on
the CGC 200.
CGC 200 installation and commissioning
instructions 4189340806 UK
Installation
DEIF A/S Page 9 of 32
To Next Page
Loading...
