Delem DAC-310 - Page 29

Delem
V1204, 2.18
Parameter 21:
Auto retract
Range : 0 - 1
Unit : -
Default : 0
Function
When set to 1, retract is automatically started when ST goes low (start cutting).
Parameter 22:
Minimum retract
Range : 0.0 – 9999.9
Unit : mm
Default : 0.0
Function
Minimum retract value.
Parameter 25:
Positioning tolerance AC
Range : 0 - 9999
Unit : millimeters
Default : 0
Function
The backgauge position will position to the new programmed position if the difference
between the actual position and the new position is greater than this tolerance.
If the difference is smaller the backgauge will stay at its actual position.
This parameter is only available for drive types 1 and 2.
Parameter 26:
AC brake enabled
Range : 0 - 1
Unit : -
Default : 1
Function
Enable AC brake output ‘BRK’. This can be used to control an AC motor with brake.