Delem DAC-310 - Page 41

Delem
V1204, 2.30
Parameter 75:
Enable Func
Range : 0 - 1
Unit : -
Default : 0
Function
Enables F (function) parameter in the user interface.
Parameter 76:
Enable Cor
Range : 0 - 1
Unit : -
Default : 0
Function
Enables Cor (correction) parameter in the user interface.
Parameter 77:
Enable repetition CY
Range : 0 - 1
Unit : -
Default : 1
Function
Enables CY (step repetition) parameter in the user interface.
Parameter 78:
Enable Steps
Range : 0 - 1
Unit : -
Default : 1
Function
Enables ST (number of steps) parameter in the user interface.
0 = no step programming possible, only manual mode available
1 = step programming available, maximum 99 steps can be programmed