Delem
V1204, 2.31
Parameter 90:
Serial number
Range : -
Unit : -
Default : -
Function
Displays the serial number of the controller. This value cannot be changed.
Parameter 91:
Hours
Range : -
Unit : hours
Default : 0
Function
Displays the total number of hours the machine has been running. The value of this parameter
is the total time the MR input has been high.
This parameter can be reset with a special code. See chapter 3.
Parameter 92:
Number of strokes
Range : -
Unit : -
Default : 0
Function
Displays the total number of strokes the machine has cut.
This parameter can be reset with a special code. See chapter 3.
To Next Page
Loading...
