Dell EMC PowerEdge R620 - Page 15

Figure 6. Back-panel features and indicators—10 hard drive system and 8 hard drive system (3 pcie expansion cards)
Item Indicator, Button, or Connector Icon Description
1 System identication button The identication buttons on the front and back panels can be used
to locate a particular system within a rack.
10 Hard Drive
System
When one of these buttons is pressed, the
system status indicator on the back
ashes until one of the buttons is pressed
again.
8 Hard Drive
System
When one of these buttons is pressed, the
LCD panel on the front and the system
status indicator on the back ashes until
one of the buttons is pressed again.
Press to toggle the system ID on and o. If the system stops
responding during POST, press and hold the system ID button for
more than ve seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press and hold
for more than 15 seconds.
2 System identication connector Allows you to connect the optional system status indicator
assembly through the optional cable management arm.
3 iDRAC7 Enterprise port Dedicated management port.
NOTE: The port is available for use only if the iDRAC7
Enterprise license is installed on your system.
4 PCIe expansion card slot (riser 1) Allows you to connect a PCIe expansion card.
5 Serial connector Allows you to connect a serial device to the system.
6 Video connector Allows you to connect a VGA display to the system.
7 PCIe expansion card slot (riser 2) Allows you to connect a PCIe expansion card.
8 USB connectors (2) Allows you to connect USB devices to the system. The ports are
USB 2.0-compliant.
9 Ethernet connectors (4) Four integrated 10/100/1000 Mbps NIC connectors
or
Four integrated connectors:
• Two integrated 10/100/1000 Mbps NIC connectors
• Two integrated 100 Mbps/1 Gbps/10 Gbps SFP+ connectors
10 PCIe expansion card slot (riser 3) Allows you to connect a PCIe expansion card.
About your system 15