h all expansion-card risers
i power supply(s)
j cooling fans
k memory modules
l cooling shroud
5 Connect the cables to the system board assembly, SAS backplane, control panel board, and the (if applicable) optical drive.
6 Route the power/data cables along the chassis wall.
7 Close the system.
8 If applicable, install the front bezel.
9 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
10 Import your new or existing iDRAC Enterprise license. For more information, see the iDRAC7 User's Guide at support.dell.com/
manuals.
Installing and removing system components 95
To Next Page
Loading...
