Figure 13. Installing the front bezel
Next steps
1. Follow the procedure listed in After working inside your system.
Hard drives
Removing a drive carrier from the drive bay
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system.
3. Using the management software, prepare the drive for removal. Power off the system and unplug the cables before removing the
drive. For more information, see the www.dell.com/storagecontrollermanuals.
4. Disconnect the power and data cables from the drive.
NOTE:
To prevent data loss, ensure that your operating system supports drive installation. See the documentation
supplied with your operating system.
CAUTION: Mixing drive carriers from previous generations of PowerEdge servers is not supported.
Installing and removing system components 37
To Next Page
Loading...
