Figure 15. Installing the hard drive carrier
Next steps
1. Connect the power and data cables to the drive.
2. Follow the procedure that is listed in After working inside your system.
NOTE:
SATA ports on the system board are corresponding to SATA devices. Please refer to System Information Label.
NOTE: "SATA 1" is for the first drive. "SATA 2" is for the ODD. "SATA 3" is for the 2nd drive. "SATA 4" is for the 3rd
drive.
Removing a drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system.
3. Remove the drive carrier from the drive bay.
Steps
1. Flex the drive bracket outwards to release the metal studs on the drive bracket from the holes on the drive.
2. Remove the drive from the carrier.
Installing and removing system components
39
To Next Page
Loading...
