EasyManua.ls Logo

Dell EMC PowerEdge T40 - Optical drives; Ports and connectors specifications; USB ports specifications; NIC port specifications

Dell EMC PowerEdge T40
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Optical drives
The PowerEdge T40 system supports the following optical drives.
Table 28. Supported optical drive type
Supported drive type Supported number of drives
Slim 9.5 mm SATA DVD+/-RW drive One
NOTE: External optical drives can be connected through the USB ports.
Ports and connectors specifications
USB ports specifications
The PowerEdge T40 system supports the USB ports mentioned below:
Table 29. PowerEdge T40 system USB specifications
Front Panel Rear Panel
Two USB 2.0-compliant Type-A ports
One USB 3.0 Type-A compliant port
One USB 3.1-compliant Type-C port
Four USB 3.0 Type-A compliant ports
Two USB 2.0 Type-A compliant ports
NIC port specifications
The PowerEdge T40 system supports a Network Interface Controller (NIC) port on the back panel, which is available in 10/100/1000
Mbps NIC configurations.
Serial connector specifications
The PowerEdge T40 system supports one serial connector on the back panel, which is a 9-pin connector, Data Terminal Equipment
(DTE), 16550-compliant.
DisplayPort specifications
The PowerEdge T40 system supports two DisplayPorts located on the back panel of the system.
Video specifications
The PowerEdge T40 system supports:
Intel UHD Graphics P630 for Intel Xeon E processor
Intel UHD Graphics 630 for Intel Core i3 processor
Intel UHD Graphics 610 for Intel Pentium Gold processor
Environmental specifications
NOTE:
For additional information about environmental certifications, refer to the
Product Environmental Datasheet
located with the Manuals & Documents on www.dell.com/support/home.
84 Technical specifications

Table of Contents

Related product manuals