Next steps
1. Replace the system fan.
Installing system fan
Prerequisites
CAUTION: Do not install or remove the system fan holding the fan blades.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system.
Steps
1. Align the grommets on the system fan base plate with the holes on the system fan frame.
2. Stretch the grommets and push the system fan toward the system fan base plate to secure the system fan in place.
3. Route the system fan cable through the routing channel on the system fan base plate.
Figure 39. Installing system fan
4. Align the system fan base plate with the slots on the chassis.
5. Slide the fan base plate into the slot until it is firmly seated.
6. Tighten the screw to secure the system fan base plate to the chassis.
7. Connect the system fan power cable to the connector on the system board.
Installing and removing system components
61
To Next Page
Loading...
