Figure 51. System board screw location
Next steps
1. Replace the following:
a. Memory modules.
b. Processor.
c. Heat sink module.
d. Expansion card, if installed
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured by using the cable
securing bracket.
3. Close the PSU assembly.
4. Follow the procedure listed in After working inside your system.
5. Let the system boot.
6. Ensure that you:
a. Update the BIOS firmware.
b. Enter the system service tag after you install the system board. For more information see Entering the service Tag.
Entering the System Service Tag by using the Service
Menu
Prerequisites
WARNING:
Service Menu only appears once after a new system board is replaced. The setting in Service Menu cannot
be undone once you apply the changes.
Installing and removing system components 71
To Next Page
Loading...
