Dell EMC PowerEdge T40 - Installing a drive into the drive carrier

Figure 16. Removing the drive from the drive carrier
Next steps
1. Install the drive into the drive carrier.
Installing a drive into the drive carrier
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system.
Steps
1. Align the screw holes on one side of the drive with the pins on the drive carrier.
2. Flex the drive bracket outward, and align the metal studs on the drive bracket to the holes on the drive and place the drive into the
drive carrier.
40
Installing and removing system components