Figure 32. Installing the optical drive
Next steps
1. Close the PSU assembly.
2. Follow the procedure that is listed in After working inside your system.
NOTE:
SATA ports on the system board are corresponding to SATA devices. Please refer to System Information Label.
NOTE: "SATA 1" is for the first drive. "SATA 2" is for the ODD. "SATA 3" is for the 2nd drive. "SATA 4" is for the 3rd
drive.
Speaker
Removing speaker
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Open the PSU hinge.
4. Disconnect the speaker cable from the connector on the system board.
NOTE:
Un-route the cable through the retention clips on the system fan base plate and system board.
Installing and removing system components 55
To Next Page
Loading...
