Dell 4320 - Presentation to Go (Ptg) Installation

Using Your Projector 67
Presentation to Go (PtG) Installation
Minimum system requirements to install PtG are as follow:
Operating System:
-Windows
Microsoft Windows XP™ Home or Professional Service pack 2/3 (32-bit
recommended), Windows Vista 32-bit, or Windows
®
7 Home or Professional
32-bit or 64-bit
- Office 2003 or Office 2007
NOTE: Presentation to Go (PtG) installation steps are the same for the 4220 and
4320 models.
In order to use your USB Viewer, you need to complete the steps below:
" Wireless and LAN " option and " Wireless connection " default are enabled.
1 Plug the USB Flash to your projector.
NOTE:
• Supports only the JPEG format photo within 10 MB x 40 M pixels.
• The PtG converter can convert your PowerPoint files into PtG files. See "PtG
Converter - Lite Application Software" on page 72.
• You can download the "PtG Converter - Lite" from the Dell Support site at:
support.dell.com.
2
At INPUT SOURCE menu, select Wireless/USB and then select USB Viewer
on the sub-menu. See "INPUT SOURCE WIRELESS/USB" on page 39.
NOTE:
1 When the Wireless and LAN function is disabled , Go to LAN Settings menu,
select the "
Enabled " in the " Wireless and LAN " option to activate the Wireless
and LAN function.
2 When the Wireless connection is disconnected, Go to Wireless Settings
menu, select the "
Connected " in the Wireless option to enable wireless
connection.