Removing the display back-
cover
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
Before working inside your computer.
After working inside your computer, follow the instructions
in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
NOTE: This chapter is applicable only if you have purchased a laptop with
non-touchscreen display.
1 Remove the base panel.
2 Remove the wireless card.
3 Follow the procedure from step 1 to step 9 in “Removing the palm rest”.
4 Remove the display assembly.
5 Remove the display bezel.
6 Remove the display panel.
7 Remove the camera.
8 Remove the display-panel AlienFX LEDs.
9 Remove the Alienware AlienHead LED board.
Procedure
1 Disconnect the camera cable from the camera module.
2 Remove the display-board cable from the routing guides on the display
back-cover.
132
To Next Page
Loading...
Need help?
General