Setting up the monitor | 25
Setting up the monitor
Connecting the stand
NOTE: The stand assembly is not pre-installed when the monitor is shipped
from the factory.
NOTE: The following instructions are applicable only for the stand that was
shipped with your monitor. If you are connecting a stand that you purchased
from any other source, follow the set up instructions that were included with
the stand.
To connect the monitor stand:
1. Align and place the stand riser on the stand base.
2. Open the screw handle at the bottom of the stand base and turn it clockwise
to secure the stand assembly.
3. Close the screw handle.
3
1
2
To Next Page
Loading...
