Dell Alienware AW2523HF - Page 50

50 | Operating the monitor
Yes No
Adjusting to this value will increase power consumption above the
default level. Do you want to continue?
Alienware 25 Monitor
AW2523HF
When you select FPS/MOBA(RTS)/SPORT under Preset Modes in the Game
menu OSD for the first time after factory reset, the following message appears:
Yes No
Adjusting to this value will increase power consumption above the
default level. Do you want to continue?
Alienware 25 Monitor
AW2523HF
NOTE: If you select No, the Brightness would be changed to 75% for these
Preset Modes.
If you press any button other than the power button to wake up monitor, the
following messages will appear depending on the selected input:
No DP signal from your device.
Press any key on the keyboard or move the mouse or wake it up.
If there is no display, press the monitor button again to select the correct
input source.
Alienware 25 Monitor
AW2523HF
If either DP, HDMI 1 and HDMI 2 input is selected and the corresponding cable is
not connected, a floating dialog box as shown below appears.
The display will go into Standby mode in 4 minutes.
www.dell.com/AW2523HF
No DP Cable
Alienware 25 Monitor
AW2523HF
When you select OSD items of Factory Reset in Other feature, the following
message will appear: