1 coin-cell battery 2 coin-cell battery cable connector
Removing the Coin-Cell Battery
Follow the instructions in “Before You Begin” on page 1. 6.
Remove the battery pack (see “Removing the Battery Pack” on page 2. 11).
Remove the compartment door (see “Removing the Compartment Door” on 3.
page 14).
Disconnect the coin-cell battery cable from the system board connector.4.
Lift the coin-cell battery o the computer base.5.
Replacing the Coin-Cell Battery
Follow the instructions in “Before You Begin” on page 1. 6.
Place the coin-cell battery in the slot on the computer base.2.
Connect the coin-cell battery cable to the system board connector.3.
Replace the compartment door (see “Replacing the Compartment Door” on 4.
page 14).
Replace the battery pack (see “Replacing the Battery Pack” on page 5. 11).
CAUTION: Before turning on the computer, replace all screws and ensure
that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
