Dell Alienware M17X R2 - Replacing the Graphics Card Blank

097
097
/
CHAPTER 21: GRAPHICS CARD BLANK
Replacing the Graphics Card Blank
Follow the instructions in “Before You Begin” on page 1. 6.
Place the graphics card blank in the computer base. 2.
Tighten the three captive screws that secure the graphics card blank to the 3.
computer base.
Replace the right bracket (see “Replacing the Brackets” on page 4. 47).
Replace the keyboard (see “Replacing the Keyboard” on page 5. 39).
Replace the center control cover (see “Replacing the Center Control Cover” 6.
on page 35).
Replace the compartment door (see “Replacing the Compartment Door” on 7.
page 14).
Replace the battery pack (see “Replacing the Battery Pack” on page 8. 11).
CAUTION: Before turning on the computer, replace all screws and ensure
that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.