Not enough free space in flash memory for resources [52]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
• Delete fonts, macros, and other data stored in the flash memory.
From the printer control panel, navigate to:
> Settings > > Settings > > Print Settings > > Utilities Menu > > Format Flash > >
Yes >
• Use a larger‑capacity flash memory card.
Note: Downloaded fonts and macros that are not stored in the flash memory are deleted when the printer is turned
off or restarted.
PPDS font error [50]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
• If the printer cannot find the requested font, then navigate to:
> Settings > > Settings > Print Settings > > PPDS menu > > Best Fit > > On >
The printer finds a similar font and reformats the affected text.
• Cancel the current print job.
Paper changes needed
Try one or more of the following:
• From the printer control panel, select Prompt for each page to continue printing.
• Select Use current supplies to continue printing using the paper loaded in the tray.
• Cancel the current print job.
Parallel port [x] disabled [56]
Do either of the following:
• From the printer control panel, select Continue to clear the message and continue printing.
The printer discards any data received through the parallel port.
• Select Reset active bin to reset the bin for a linked set of bins.
Troubleshooting 182
To Next Page
Loading...
Need help?
General
