152 Dell™ Printer Configuration Web Tool
Va lu es :
NOTE: The settings in the Port Settings page will be valid only when the printer is rebooted. When you change or configure the
settings, click the Apply New Settings button to apply the new settings.
TCP/IP
Purpose:
To configure the IP address, subnet mask, and gateway address of the printer.
Ethernet
*1
Ethernet Settings Auto Detects the Ethernet transmission rate and the
duplex settings automatically.
10Base-T Half-Duplex Selects 10Base-T Half-Duplex as the default
value.
10Base-T Full-Duplex Selects 10Base-T Full-Duplex as the default
value.
100Base-TX Half-Duplex Selects 100Base-TX Half-Duplex as the default
value.
100Base-TX Full-Duplex Selects 100Base-TX Full-Duplex as the default
value.
1000Base-T Full-Duplex Selects 1000Base-T Full-Duplex as the default
value.
Current Ethernet Settings Displays the current settings of the Ethernet.
MAC Address Displays the MAC address of the printer.
Port Status LPD Sets whether to enable LPD.
Port9100 Sets whether to enable Port9100.
IPP Sets whether to enable IPP.
WSD Print Sets whether to enable WSD Print.
FTP Sets whether to enable FTP.
SMB Sets whether to enable SMB.
Bonjour (mDNS) Sets whether to enable Bonjour (mDNS).
E-Mail Alert Sets whether to enable E-Mail Alert.
Teln et Sets whether to enable Telnet.
SNMP Sets whether to enable SNMP.
SNTP Sets whether to enable SNTP.
Google Cloud Print Sets whether to enable Google Cloud Print.
*1
This item is available only when the printer is connected using an Ethernet cable.
To Next Page
Loading...
Need help?
General
